Identification Number:
........Not Applicable
PROPER SHIPPING NAME:
........Not Regulated
HAZARD CLASS:
........Not Applicable
GENERIC DESCRIPTION:
........Floor Finish
1)
COMPOSITIONAL INFORMATION (% w/w)
DEG Methyl Ether
....CAS#....111773...........2-7%...........
Tributoxyethyl Phosphate
....CAS#....78513...........1-5%...........
Zinc Ammonium Caarbonate
....CAS#....38714475...........1-5%...........25
ppm
2) PHYSICAL PROPERTY INFORMATION
APPEARANCE:White milky liquid
ODOR:Typical acrylic odor
pH:
VISCOSITY:
MELTING/FREEZING POINT: F.P. < 0º C (32º F)
BOILING POINT: Approx. same as water
VAPOR PRESSURE: Not Determined
VAPOR DENSITY: Less than air
SOLUBILITY IN WATER: Complete
PERCENT VOLATILE: 78%
SPECIFIC GRAVITY: 1.055
3) FIRE AND EXPLOSION HAZARD INFORMATION
FLASH POINT: None
AUTO IGNITION TEMP.: Not applicable
METHOD USED: Not applicable
EXPLOSION LIMITS:
LEL: Not applicable
UEL: Not applicable
EXTINGUISHING MEDIA: Foam or carbon dioxide or dry chemical.
FIRE AND EXPLOSION HAZARDS: None
4) HEALTH HAZARD INFORMATION
EFFECTS OF OVEREXPOSURE:
EYES: Can cause mild to moderat irritation.
SKIN: Prolonged or repeated contact can cause irritation
BREATHING: Excessive inhalation of vapors can cause nasal and
respiratory irritation.
INGESTION: Can cause gastrointestinal irritation, nausea, vomiting, and
diarrhea.
EMERGENCY AND FIRST AID PROCEDURES:
If Swallowed: Call a physician or Poison Control Center. Unless advised
otherwise, induce vomiting by giving either syrup of ipecac followed by
2 glasses of water or by sticking finger down throat. Do not induce
vomiting or give anything by mouth to a drowsy or unconscious person.
If On Skin: Wash with plenty of soap and water. Get medical attention if
irritation persists.
If Inhaled: Remove victim to fresh air. If not breathing, give
artificial respiration, preferably mouth-to-mouth. Administer oxygen if
available. Get medical attention.
If In Eyes: Flush with plenty of water for ten minutes. Get medical
attention if irritation persists.
|
5)
REACTIVITY INFORMATION
STABILITY: Stable
HAZARDOUS POLYMERIZATION: Will not occur
INCOMPATIBILITY: Strong oxidizing agents
6) SPILL
OR LEAK PROCEDURE INFORMATION
ACTION TO TAKE FOR SPILLS: Stop discharge if it can be performed safely,
and contain material. Recover with pump or vaccuum or use an absorbent
material. Place contaminated material in suitable container for
disposal. Do not flush to sewer, stream or other bodies of water.
7)
PROTECTIVE EQUIPMENT
VENTILATION: Local exhaust
RESPIRATORY PROTECTION: If the TLV of the product or any compound is
exceeded, an approved air supply respirator is advised
PROTECTIVE GLOVES: Chemical resistant gloves such as nitrile rubber
EYE PROTECTION: Chemical splash goggles are advised
OTHER PROTECTIVE EQUIPMENT: Wear impervious clothing and boots
8)
STORAGE AND HANDLING INFORMATION
Handle with resonable care. Avoid breathing vapors. Store in cool dry
place. Dispose of empty containers in accordance with local, state, and
federal guidelines.
This product contains DEG Methyl Ether & Dibutyl Phthalate which are
subject to the reporting requirements of Section 313 of the Emergancy
Planning and Community Right-to-Know Act of 1986 and of 40 CFR372.
Storage temperature: Max.: 35º C Min.: 5º C.
Keep out of reach of children. Harmful if swallowed, adsorbed through
skin, or if inhaled. Avoid breathing of spray mist or contact with skin,
eyes, clothing.
HAZARD RATING:
4 = EXTREME
3 = HIGH
2 = MODERATE
1 = SLIGHT
|